Nút nhấn khẩn

Addressable manual fire detector IPR 513-11 prot. R3 is designed for manual “Fire” signal activation in addressable fire and security and fire alarm systems. It is designed to operate as a part of address system controlled by receive-control alarm device Rubezh-2OP prot.R3.

Power supply	from DCL (28 – 36 V)
Button pressure force, at least	25 N
LED flashing rate in “Fire” mode	2 Hz
Overall dimensions of the module, no more than	88х86х45 mm
Weight, no more than	100 g
Operating temperature range	from -25 to +55°С
Average service life, at least	10 years

Design and manufacturing process of the detector designed for multiple activation and deactivation ensure trouble-free operation of the device for almost unlimited period of time.

The addressable manual detector IPR 513-11 prot. R3 consists of a base, a case, and a safety cover. The base accommodates a PCB with radio elements and a terminal block for two-wire DCL cabling.

The manual detector transmits a “Fire” signal to the fire alarm control unit when the button is pressed.

The “Fire” signal is cleared by reset of the button by means of the key included in scope of supply. In order to return the button, insert the key into a hole located in the button center and press on it until the button clicks off.

A red LED is provided to indicate operating conditions and trouble-free operation of the addressable manual detector, which flashes once every 3-5 s in “NORMAL” state and twice every 1 s in “FIRE” state.

Power supply of the detector and transmission of the “Fire” signal are ensured via DCL.

Design of the detector provides for its sealing.

Detector IPR 513-11 prot.R3 is produced in a red case